Analyzers      Gas Notes      Opacity      Chemiluminescence      Paramagnetic      NDIR (Non-Dispersive    InfraRed)      Flame Ionization      Thermal Conductivity      Polaragraphic      Multi-Component      Transflectance (UV)      Trace Moisture      Zirconium Oxide      Controllers, Boiler      Etalon analyzers      Chart Recorders      Fan/Damper Drives     :: analyzers ::  (sort by measurement)   technical information           = Discontinued or Obsolete - Opacity Opacity is the degree to which the transmission of light is reduced or the degree to which visibility of a background, as viewed through the diameter of a plume, is reduced.  A transmissometer (or opacity analyzer) measures the amount of light that is lost to scattering or absorption in the emission's effluent.  It is expressed in percentage usually, but sometimes in Ringelmann numbers.  OPM2000   OPM2000A   OPM2000R   OPM2001 - Chemiluminescence The method of detection where a chemical reaction generating light is used to measure the amount of Oxides of Nitrogen (NOx) found typically in a combustion process flue gas.  951   951A  951C  951E   955   958   NGA2000 CLD Module  NGA2000 WCLD Module - Paramagnetic This detection method is based on the effect of magnetic lines of flux on oxygen molecules.  755/G  755A  755EX  755R OXYNOS 100  NGA2000 PMD   NGA2000 PMD2  NGA2000 FR-PMD   TO2  - NDIR (Non-Dispersive InfraRed) By passing infrared energy through a cavity to a detector the measurement is based on the difference in response of the detector with the gas-of-interest present in the cavity versus its response with no gas of interest in the cavity.  5100/A (in-situ CO2 NDIR measurement)   815  864   865   865EX   867   868   870   880   880A  NGA2000 NDIR Module  - Flame Ionization Flame ionization is the method of detection where the total amount of carbon atoms (THC-total hydrocarbons) in a gas stream is determined by a measuring a minute current proportional to the amount of THC present in the combustion chamber.  400   400A  402   402RS   404   FID   FID2  MCFID   TFID - Thermal Conductivity Gases are measured by their ability to affect the transfer of heat away from the detecting heat source.  7C   7D   CAT7   HYDROS 100 - Polaragraphic Oxygen concentration derived from a proportional current flow between the anode and cathode in an electrochemical cell.  7001   7001D   7002D   7003D   7003M   OXYNOS 100  ROX/GP  ROX/GT - Multi-Component These units combine measurement "benches" utilizing several different principles of analysis, i.e. an NIDR, Thermal Conductivity, & an Oxygen cell all in the same unit.  NGA2000/MLT MLT1 MLT2 MLT3 MLT4 Platforms Power Supplies I/O cards  CAT100  CAT200  BINOS - Transflectance (UV) These analyzers use spectrally selective mirrors to isolate Ultraviolet spectral pass-bands prior to actual detection.  890  SO2  890  Cl2 - Trace Moisture This measurement is based on the absorption and electrolysis of moisture in and electrolytic cell.  340  - Zirconium Oxide This method of analysis combines the ionization of O2 and a catalytic reaction between two platinum electrodes to produce a millivolt signal proportional to the concentration of O2 in the sample.  132   200   218   225   240  3081   4081   5081  Oxymitter 4000  Oxymitter 5000  OXT4A/C  OXT5A/C  World Class (Universal)  World Class 3000 - Controllers, Boiler Multi loop controllers typically used to control the fuel/air ratio in combustion processes.  1500   1500A  EC3  TC200  - Etalon analyzers The means of differential gas absorption measurement where spectral correlation is removed by the use of an electro-optic modulator.  9100   9200  - Chart Recorders  All Chessell models - Fan/Damper Drives  All Hagan/Rosemount models